PC-755SS is a slow set, rapid curing, 100% solids, flexible, two-component polyurea elastomer spray coating material. PC-755SS is used by itself or in combination with other materials to produce coatings, liners, wearing courses and resilient surfaces on concrete and other substrates. PC-755SS produces an extremely tough film. PC-755SS may be applied in all positions and to any properly prepared substrates. PC- 755SS is inert, it will not hydrolyze, leach, or contaminate other materials, and is paintable. PC- 755SS is relatively moisture and temperature insensitive, allowing application in the most problematic ambient conditions.
Mix Ratio by Volume
Gel Time (Seconds)
Tack-Free Time (Seconds)
120 – 180
Shore D Hardness, ASTM D2240
Shore A Hardness, ASTM D2240
Elongation %, ASTM D638, Type IV
220 – 250
Tensile Strength (PSI), ASTM D638, Type IV
Tear Strength (lb./in.), ASTM D624, Die C
Taber Abrasion, ASTM D4060
(H-18 Wheel, 1000 Cycles)
180 – 200
The values stated in this technical data sheet are produced under controlled laboratory conditions.